Service Brakes, Hydraulic › Foundation Components › Master Cylinder Vehicle Recalls

Honda (American Honda Motor Co.) is recalling certain 2016-2020 Acura ILX vehicles. Contaminated brake fluid may cause a seal inside the brake master cylinder to deform, which can cause an internal brake fluid leak and reduce brake function.

Ford Motor Company (Ford) is recalling certain 2017-2018 F-150, Expedition, and Lincoln Navigator vehicles. The brake master cylinder may allow brake fluid to leak from the front wheel circuit into the brake booster.

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2024 Atlas and 2024 Atlas Cross Sport vehicles. The brake master cylinder may have been assembled with an incorrect secondary piston spring retainer, which can block the brake fluid port.

Honda (American Honda Motor Co.) is recalling certain 2020-2021 Civic, 2020-2023 Ridgeline, 2021-2023 Passport, 2021-2022 Pilot, and 2020 Acura MDX vehicles. The tie rod fastener that connects the brake booster and the brake master cylinder may have been improperly assembled during manufacturing, which can cause the brake master cylinder to separate from the booster assembly.

Hyundai Motor America (Hyundai) is recalling certain 2021 Accent vehicles. The brake master cylinder may have been manufactured with sharp edges that can damage the inner oil seal, resulting in reduced braking performance.

Kia Motors America (Kia) is recalling certain 2020-2021 Rio vehicles. The brake master cylinder may have been manufactured with sharp edges that can damage the inner oil seal, resulting in reduced braking performance.

Chrysler (FCA US, LLC) is recalling certain 2020-2021 Ram 1500 Classic SLT trucks. Certain vehicles were built without the retaining clip that secures the master cylinder push rod to the brake pedal, which can cause the brake pedal to separate from the brake system.

Tenneco Automotive (Tenneco) is recalling certain Beck/Arnley Master Cylinders, part number 072-9831, sold as aftermarket or replacement parts for 2004-2018 Volkswagen Jetta, and 2012-2019 Volkswagen Beetle vehicles. The fluid seal crimp on the master cylinder may be insufficient, causing brake fluid to leak or the cylinder to come apart.

Ford Motor Company (Ford) is recalling certain 2014-2017 F-150 pickup trucks equipped with 3.5L Ecoboost engines. The brake master cylinder may leak brake fluid into the brake booster.

Volkswagen Group of America, Inc. (Audi) is recalling certain 2018-2019 Audi Q5 and SQ5 vehicles. The brake master cylinder casting may be too short.

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2019 Toyota Tacoma vehicles. Improper machining of the brake master cylinder may result in internal damage of one of the seals, affecting brake performance.

Nissan North America, Inc. (Nissan) is recalling certain 2015-2017 Nissan Juke Nismo RS vehicles. Due to a problem within the brake master cylinder, brake fluid may leak into the brake booster, reducing brake performance.

American Honda Motor Co., Inc. (Honda) is recalling certain model year 2001-2010 and 2012-2015 GL1800, 2001-2005 GL1800A and 2013-2015 GL1800B motorcycles. The rear brakes of the affected motorcycles may drag after the brakes are released.

Nissan North America, Inc. (Nissan) is recalling certain model year 2013 Titan and Armada vehicles manufactured February 22, 2013, through May 3, 2013. The affected vehicles have a brake master cylinder which may intermittently reduce the pressure supplied to the front brakes.

HONDA IS RECALLING CERTAIN MODEL YEAR 2001-2010, AND MODEL YEAR 2012 GL1800 GOLDWING MOTORCYCLES. UNDER CERTAIN CONDITIONS, THERE IS A POSSIBILITY THAT THE COMBINED BRAKING SYSTEM'S SECONDARY MASTER CYLINDER MAY CAUSE THE REAR BRAKE TO DRAG.

HONDA IS RECALLING CERTAIN MODEL YEAR 2005-2007 ODYSSEY AND ACURA RL VEHICLES. BRAKE FLUID CONTAINING POLYMERS IS USED THAT ACTS AS A LUBRICANT FOR CERTAIN BRAKE SYSTEM COMPONENTS. IF REPLACEMENT BRAKE FLUID IS USED THAT DOES NOT CONTAIN SUCH POLYMERS, OR THAT CONTAINS ONLY SMALL AMOUNTS, A PART OF THE RUBBER SEAL LOCATED AT THE REAR OF THE BRAKE MASTER CYLINDER MAY BECOME DRY, AND THE SEAL MAY CURL DURING MOVEMENT OF THE PISTON. IF THIS OCCURS, A SMALL AMOUNT OF BRAKE FLUID COULD SLOWLY LEAK FROM THE SEAL INTO THE BRAKE BOOSTER.

TOYOTA IS RECALLING CERTAIN MODEL YEAR 2005-2006 AVALON, MODEL YEAR 2004-2006 HIGHLANDER, MODEL YEAR 2004-2006 LEXUS RX, AND MODEL YEAR 2006 LEXUS GS AND IS VEHICLES. BRAKE FLUID CONTAINING POLYMERS IS USED THAT ACTS AS LUBRICANTS FOR CERTAIN BRAKE SYSTEM COMPONENTS. IF REPLACEMENT BRAKE FLUID IS USED THAT DOES NOT CONTAIN SUCH POLYMERS, OR THAT CONTAINS ONLY SMALL AMOUNTS, A PART OF THE RUBBER SEAL LOCATED AT THE REAR OF THE BRAKE MASTER CYLINDER MAY BECOME DRY, AND THE SEAL MAY CURL DURING MOVEMENT OF THE PISTON. IF THIS OCCURS, A SMALL AMOUNT OF BRAKE FLUID COULD SLOWLY LEAK FROM THE SEAL INTO THE BRAKE BOOSTER.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2010 LEFT HAND DRIVE JEEP LIBERTY, DODGE NITRO AND RAM 1500 TRUCK; RIGHT AND LEFT HAND DRIVE JEEP WRANGLER VEHICLES. THESE VEHICLES MAY HAVE BEEN BUILT WITH AN IMPROPERLY FORMED MASTER CYLINDER TO HYDRAULIC CONTROL UNIT (HCU) BRAKE TUBE ASSEMBLY END FLARE.

NISSAN IS RECALLING CERTAIN MODEL YEAR 2008 SENTRA PASSENGER VEHICLES EQUIPPED WITH BOSCH MASTER CYLINDERS. BRAKE FLUID MAY LEAK FROM THE MASTER CYLINDER. IF THE AMOUNT OF BRAKE FLUID IN THE MASTER CYLINDER RESERVOIR DECREASES TO BELOW THE MINIMUM LEVEL, THE BRAKE SYSTEM WARNING INDICATOR WILL ILLUMINATE AS DESIGNED AND THE BRAKES WILL NOT FUNCTION PROPERLY.

NISSAN IS RECALLING 169,202 MY 2007-2008 SENTRA PASSENGER VEHICLES EQUIPPED ROBERT BOSCH MASTER CYLINDER. DUE TO THE MACHINING IRREGULARITY BY THE SUPPLIER, THE INTERNAL SEAL GROOVE IN THE BODY OF SOME BRAKE MASTER CYLINDERS MAY ALLOW FOR A GAP IN THE GROOVE CONTACT AREA OF THE SEAL. THIS MAY RESULT IN BRAKE FLUID SLOWLY LEAKING FROM THE MASTER CYLINDER INTO THE BRAKE BOOSTER ASSEMBLY, CAUSING THE BRAKE WARNING LIGHT TO ILLUMINATE.

SPRINTER IS RECALLING 34 MY 2007-2008 DODGE AND FREIGHTLINER SPRINTER 3500 CARGO VANS. SOME OF THESE VANS MAY NOT HAVE HAD THE CORRECT BRAKE COMPONENTS INSTALLED.

VOLVO IS RECALLING 1,114 MY 2007 C30, C70, S40, AND V50 PASSENGER VEHICLES. A SOFT ANODIZED LAYER IN THE MASTER CYLINDER MAY TRIGGER EARLY WEAR ON A RUBBER SEAL THAT CAN RESULT IN INTERNAL LEAKAGE OF BRAKE FLUID. IF AFFECTED, THE DRIVER MAY EXPERIENCE REDUCED BRAKE PERFORMANCE WHEN APPLYING AND MAINTAINING FORCE OF THE BRAKE PEDAL.

CERTAIN CARDONE MASTER CYLINDERS WITH PART NUMBERS 10-2925, 10-2987, 10-2987MZA, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, AND 11-3156, AND WITH DATE CODES LOWER THAN DCA7078 SOLD AS REPLACEMENT EQUIPMENT FOR USE ON THE VEHICLES LISTED ABOVE. THE SEAL ON MASTER CYLINDER CAN FAIL AND LEAK BRAKE FLUID.

ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH ANTI-LOCK BRAKES, THE BRAKE MASTER CYLINDER, WHICH CONTROLS THE FLUID PRESSURE TO THE VEHICLE'S BRAKES, MAY ALLOW BRAKE FLUID TO BYPASS INTERNALLY DURING STOPPING.

ON CERTAIN PASSENGER VEHICLES, ONE OF FOUR SEALS INSIDE THE MASTER CYLINDER MAY HAVE BEEN INSTALLED IMPROPERLY. AS A RESULT, THE MASTER CYLINDER MAY UNEXPECTEDLY BY-PASS HYDRAULIC BRAKING FORCE PRESSURE AND ALLOW A LONGER THAN NORMAL PEDAL STROKE.

CERTAIN PASSENGER VEHICLES HAVE THE POSSIBILITY THAT THE RECESS RETAINS A RUBBER SEAL RING, WHICH IS LOCATED AT THE END OF THE CYLINDER BODY, AND MAY BE CORRODED DUE TO AN IMPROPER WASHING PROCESS.

ON CERTAIN MOTORCYCLES, AN INCORRECT SEALING RING WAS MOUNTED TO THE PISTON OF THE REAR BRAKE MASTER CYLINDER.

ON CERTAIN PASSENGER VEHICLES, SOME BRAKE MASTER CYLINDERS MAY HAVE INTERNAL CORROSION, RESULTING IN REDUCED BRAKING PERFORMANCE AND INCREASED STOPPING DISTANCES.

ON CERTAIN PASSENGER VEHICLES, THE BRAKE MASTER CYLINDERS MAY NOT FUNCTION PROPERLY IN AMBIENT TEMPERATURES BELOW FREEZING 32 DEGREES FAHRENHEIT AND LOWER).

VEHICLE DESCRIPTION: SPORT UTIITY VEHICLES. THE RESERVOIR FILLER CAP OF THE BRAKE MASTER CYLINDER MAY INDUCE A VACUUM, INTRODUCING SOME AIR INTO THE BRAKE MASTER CYLINDER RESERVOIR. THIS COULD CAUSE ABNORMAL BRAKE NOISE AND INCREASED PEDAL STROKE WHEN THE BRAKES ARE APPLIED.

VEHICLE DESCRIPTION: NON-ABS EQUIPPED PASSENGER VEHICLES. THE BRAKE MASTER CYLINDER PISTON RETAINER SNAP RING MAY HAVE BEEN BENT INWARD DURING THE ASSEMBLY PROCESS. THE MASTER CYLINDER PISTON MAY BE IN A "BRAKE APPLIED" POSITION DUE TO THE DAMAGED PISTON RETAINER SNAP RING. WHEN THE PISTON IS IN THE APPLIED POSITION, THE FLUID COMPENSATION PORTS ARE CLOSED WHICH RESULTS IN A BRAKE DRAG CONDITION.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. CERTAIN RESERVOIR TANK CAPS ON THE BRAKE MASTER CYLINDER WERE PRODUCED WITH A WORN OUT DIE AND LACK VENTILATION HOLES. AS A RESULT, THE PRESSURE IN THE RESERVOIR TANK CAN DROP GRADUALLY AS THE BRAKE PAD OR SHOE WEARS AND AMBIENT TEMPERATURE DROPS. ALSO, THE PRESSURE COULD REACH A POINT THAT THE BRAKE CALIPER AND DRUM CYLINDER ARE PULLED BACK BY THE VACUUM IN THE RESERVOIR TANK WHEN THE VEHICLE IS PARKED FOR A LONG TIME.