Steering › Gear Box › Shaft Sector Vehicle Recalls

Daimler Vans USA, LLC (Daimler Vans) is recalling certain 2019 Mercedes-Benz Sprinter VS30 vehicles. The steering shaft that connects to the steering gear may disconnect without warning.

GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET CRUZE VEHICLES MANUFACTURED FROM OCTOBER 2, 2009, THROUGH APRIL 21, 2011. THE BOLT ATTACHING THE INTERMEDIATE STEERING SHAFT TO THE STEERING GEAR INPUT SHAFT MAY NOT HAVE BEEN PROPERLY INSTALLED.

HYUNDAI IS RECALLING CERTAIN MODEL YEAR 2011 SONATA VEHICLES MANUFACTURED FROM DECEMBER 11, 2009, THROUGH SEPTEMBER 10, 2010. ON SOME OF THESE VEHICLES THE STEERING COLUMN INTERMEDIATE SHAFT UNIVERSAL JOINT CONNECTIONS MAY HAVE BEEN EITHER IMPROPERLY ASSEMBLED OR INSUFFICIENTLY TIGHTENED.

HYUNDAI IS RECALLING CERTAIN MODEL YEAR 2011 SONATA VEHICLES MANUFACTURED FROM DECEMBER 11, 2009, THROUGH SEPTEMBER 10, 2010. ON SOME OF THESE VEHICLES THE STEERING COLUMN INTERMEDIATE SHAFT UNIVERSAL JOINT CONNECTIONS MAY HAVE BEEN EITHER IMPROPERLY ASSEMBLED OR INSUFFICIENTLY TIGHTENED.

VOLVO IS RECALLING CERTAIN MODEL YEAR 2010-2011 C30, MODEL YEAR 2010 S40 AND V50 VEHICLES EQUIPPED WITH 6 SPEED MANUAL TRANSMISSIONS. THE GEARSHIFT LEVER STUD ASSEMBLY MAY NOT HAVE BEEN TIGHTENED TO THE CORRECT SPECIFICATION DURING ASSEMBLY. IF THE GEARSHIFT LEVER CABLE OR STUD ASSEMBLY BECOMES LOOSE, IT MAY NOT BE POSSIBLE TO ENGAGE, DISENGAGE OR SHIFT GEARS.

NISSAN HAS NOTIFIED NHTSA OF A DEFECT IN CERTAIN MODEL YEAR 2010 FRONTIER, PATHFINDER, AND XTERRA VEHICLES MANUFACTURED FROM FEBRUARY 22, 2010 TO MARCH 13, 2010. ON SOME OF THE POTENTIALLY AFFECTED VEHICLES, THE FASTENERS SECURING THE PASSENGER FRONT AIR BAG MODULE, AND ALSO THE FASTENERS SECURING THE STEERING SHAFT POSITIONING BRACKET MAY NOT HAVE BEEN TIGHTENED TO THE PROPER TORQUE SPECIFICATION.

ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING GEAR IF THE PINCH BOLT COMES LOOSE.

ON CERTAIN TRUCKS, THE BOLT THAT ATTACHES THE INTERMEDIATE STEERING SHAFT TO THE STEERING GEAR MAY NOT MEET SPECIFICATION. THE BOLT MAY FRACTURE RESULTING IN THE LOSS OF STEERING.