Suspension › Front › Control Arm › Lower Ball Joint Vehicle Recalls

Ford Motor Company (Ford) is recalling certain 2021-2026 Bronco Sport and 2022-2026 Maverick vehicles. The front lower control arm ball joints may have been incorrectly installed or incorrectly repaired at the vehicle assembly plant, allowing the control arm to disconnect from the front wheel knuckle.

Tenneco Automotive (DRiV) is recalling certain aftermarket ball joints for 2004-2007 Toyota Sequoia and 2004-2006 Toyota Tundra vehicles, MOOG part number K80521, K80522, NAPA part number NCP2601633, NCP2601634, ACDelco part number 45D2344, and 45D2345. The ball joint housing may have inadequate hardness, causing premature failure.

Hyundai Motor America (Hyundai) is recalling certain 2020 Elantra vehicles. The lower control arm ball joint fasteners may have been insufficiently tightened allowing the ball joint to detach from the lower control arm.

General Motors LLC (GM) is recalling certain 2015-2018 Chevrolet Trax vehicles. A joint in one or both of the front lower control arms may have been improperly welded. An improperly welded joint may break, resulting in the partial separation of the lower control arm from the vehicle.

General Motors LLC (GM) is recalling certain 2017-2019 Chevrolet Trax vehicles. A joint in one or both of the front lower-control arms may have been improperly welded. An improperly welded joint may break, resulting in the partial separation of the lower-control arm from the vehicle.

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Volkswagen Tiguan and Tiguan long wheel base (LWB) vehicles. The nut that holds the lower ball joint of the front wheel on each side of the vehicle may be loose or improperly tightened.

Mazda North American Operations (Mazda) is recalling certain model year 2007-2012 Mazda CX-7 vehicles manufactured February 14, 2006, to May 9, 2012. In the affected vehicles, water may enter the front suspension ball joint fittings. If the water is contaminated with salt, such as from driving on snowy roads that have been treated, the ball joint may corrode and separate from the lower control arm, resulting in a loss of steering control.

Mazda North American Operations (Mazda) is recalling certain model year 2007-2014 CX-9 vehicles manufactured October 24, 2006, to December 28, 2013. The affected vehicles have front suspension ball joints that may corrode from water leaking into the fitting.

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2014 FJ Cruiser vehicles equipped with an optional "Trail Teams Ultimate Edition" package, in which the front shock absorbers and springs were replaced at vehicle processing centers. In some of these vehicles the bolts which secure the front lower ball joint to the steering knuckle and/or the front suspension lower arm to the front cross member assemblies might have been tightened with insufficient torque when the front shock absorbers and springs were replaced during the installation process.

AFFINIA IS RECALLING CERTAIN AFTERMARKET FRONT SUSPENSION LOWER BALL JOINTS, NAPA PART NO. 2601662, THAT MAY HAVE BEEN MISTAKENLY INSTALLED IN CERTAIN MODEL YEAR 2004 - 2008 ACURA TL VEHICLES DUE TO A MISTAKE IN A NAPA AND NAPA DEALERS' PARTS APPLICATION CATALOGUE.

QUALIS AUTOMOTIVE IS RECALLING CERTAIN AFTERMARKET BALL JOINTS SOLD FOR USE ON CERTAIN PASSENGER VEHICLES. THE SOCKET MAY HAVE BEEN EXCESSIVELY HARDENED WHICH COULD CAUSE IT TO CRACK NEAR THE RETAINING RING GROOVE ALLOWING THE BALL STUD TO SEPARATE UNDER IMPACT LOAD. THE SUBJECT BALL JOINTS WERE SOLD AS FOUR PART NUMBERS, D10945, D10946, G10945, AND G10946. THE AFFECTED CONTROL ARMS, D10945 AND D10946, ARE STAMPED WITH THE FOLLOWING DATES ON THE BALL JOINTS: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, AND 116609. THE G10945 AND G10946 ARE THE SAME PART AS THE D10945 AND D10946 RESPECTIVELY. THEY ARE LABELED DIFFERENTLY DEPENDING ON THE AFTERMARKET CUSTOMER.

MASERATI IS RECALLING 7,912 MY 2008 GRAN TURISMO, QUATTROPORTE, AND ALFA ROMEO VEHICLES. INCORRECTLY TORQUED UPPER AND LOWER BALL JOINT NUTS MAY CAUSE THE BALL JOINT NUTS TO LOOSEN.

ON CERTAIN TRUCKS AND MINI VANS, DUE TO POSSIBLE IMPROPER FINISHING OF THE FRONT SUSPENSION LOWER BALL JOINT, SOME BALL JOINTS MAY EXPERIENCE AN INCIDENTAL DETERIORATION OF THE INTERNAL LUBRICATION. THIS MAY CAUSE THE BALL JOINT TO WEAR AND LOOSEN PREMATURELY, WHICH COULD RESULT IN INCREASED STEERING EFFORT, REDUCED VEHICLE SELF-CENTERING, AND NOISE IN THE FRONT SUSPENSION.

ON CERTAIN TRUCKS, THE CONSTANT TENSION FRONT LOWER BALL JOINTS MAY EXPERIENCE CONTAMINATION. IF THE VEHICLE IS OPERATED FOR AN EXTENDED PERIOD WITH THIS CONDITION, THE BALL JOINT MAY EVENTUALLY EXPERIENCE WEAR AND LOOSENESS.

ON CERTAIN PASSENGER VEHICLES, DUE TO IMPROPER FORGING OF THE LOWER CONTROL ARM, CRACKS MAY OCCUR IN THE BALL JOINT SOCKET.

ON CERTAIN SPORT UTILITY VEHICLES, DUE TO A MANUFACTURING ISSUE IN THE FRONT SUSPENSION LOWER BALL JOINT, THERE IS A POSSIBILITY THAT THE SURFACE OF THE BALL OF THE JOINT MAY HAVE BEEN SCRATCHED. THE BALL JOINT MAY EVENTUALLY EXPERIENCE EXCESSIVE WEAR AND LOOSENESS, RESULTING IN INCREASED STEERING EFFORT.

ON CERTAIN SPORT UTILITY VEHICLES, THE LOWER CONTROL ARM BALL JOINTS CAN EXPERIENCE A LOSS OF LUBRICATION THAT CAN LEAD TO CORROSION, ACCELERATED WEAR, AND POSSIBLE SEPARATION FROM THE STEERING KNUCKLE.

CERTAIN MINIVANS HAVE AN INTERFERENCE CONDITION BETWEEN THE LOWER BALL JOINT RUBBER BOOT AND THE STEERING KNUCKLE (BOTH LEFT/RIGHT SIDES), WHICH COULD RESULT IN CUTTING OF THE BOOT THAT IS INTENDED TO SEAL THE BALL JOINT. IF THE LOWER BALL JOINT BOOT WERE CUT, CONTAMINATION FROM THE ROAD (SALT, DIRT, WATER, ETC.) COULD ENTER THE BALL SOCKET AREA OF THE BALL JOINT CAUSING THE JOINT TO WEAR OUT TOO QUICKLY.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT SUSPENSION LOWER BALL JOINTS WERE NOT TIGHTENED TO SPECIFICATIONS WHEN THEY WERE ATTACHED TO THE LOWER CONTROL ARMS.

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT SUSPENSION LOWER BALL JOINTS WERE NOT TIGHTENED TO SPECIFICATIONS WHEN THEY WERE ATTACHED TO THE LOWER CONTROL ARMS.